HOME   |   13288 Newt Dr.  Neosho, MO 64850   Ph. (417) 451-1789   1-866-451-1789   Fax. (417) 451-3111   helpdesk@ceslive.com

   WARNING  

FALLS CAN CAUSE SERIOUS

INJURY OR DEATH

Standard equipment on Bashlin belts includes: 4 D-rings for gut strap attachment (exception - Hip-Grip and Rest-A-Back belts), tape sling, knife snap, glove bag ring and hammer loop on the left side of the belt.

Note: D18, D19, and D20 tool belts have 3 tool loops due to the shorter belt section.

(A) STANDARD - FIXED "D"

#C1511N

(B) SEMI-FLOATING - FIXED "D"

#C72HR, C71N

(C) SEMI-FLOATING - SHIFTING "D"

#C60FH, C76, C88, C88X, C160N, C160NL

(D) HIP-GRIP

#C71NG, C72HRG, C76G, C88G, C88GP, C160NG, C1511NG

(E) REST-A-BACK

#C71NB, C72HRB, C76B, C88B, C88BP, C160NB, C1511NB

TOOL BELT STYLES

BELT ADJUSTMENT IN INCHES - PER ASTM F887
D Size In.	Minimum	Center Hole	Maximum	Tool Loops
D18	32	36	40	3
D19	33	37	41	3
D20	34	38	42	3
D21	36	40	44	4
D22	37	41	45	4
D23	38	42	46	4
D24	40	44	48	4
D25	41	45	49	4
D26	42	46	50	4
D27	44	48	52	4
D28	45	49	53	4

To Find Your "D" Size

1. Locate the point where the heel of the "D" ring should rest. As the photo illustrates, this is approximately 4" down from the top of the hip bone.

2. Begin to measure from this point. Measure around the buttocks to the same point on the opposite side.

When a properly sized tool belt is worn, the D-rings will point nearly straight ahead and the tongue adjustment will be in the center holes as shown in photo 3.

To properly size the Padded Rest-A-Back or Hip-Grip tool belts, add 2" to your standard "D" measurement.